Page 1 of 1

Explorist 510 Sat-Anzeige

Posted: Sun Jul 15, 2018 5:49 am
by hallal
Hallo, habe den exmod und mit diesem IGO 8 benutzt. Nach dem Ausschalten von IGO und dem Einschalten von Magellan wird oben rechts das Sat-Symbol (die senkrechten Bälkchen) blinkend angezeigt. Der Sat-Empfang funkioniert aber ohne Probleme.
Hat jemand hier im Forum eine Erklärung für dieses Verhalten.

Re: Explorist 510 Sat-Anzeige

Posted: Tue Sep 18, 2018 6:42 am
by dimonster2
Try to switch the navigator off, remove batteries, insert batteries again an power on the navigator.
By the way, what is inside your eXmod.ini file?

Re: Explorist 510 Sat-Anzeige

Posted: Mon Oct 22, 2018 4:57 pm
by hallal
Thanks for Your replay.
Exmod.ini file :
SDMMC\iGO8\iGO8.exe;iGO 8.3;1
\SDMMC\eXmod\Utilities\Suspend.exe;Suspend;0
\SDMMC\ozi\OziExplorerCE.exe;OZI CE;0

I resolved the Problem by switching the GPS off and then on again.

Re: Explorist 510 Sat-Anzeige

Posted: Tue Oct 23, 2018 2:46 pm
by dimonster2
You can also try this:
1) connect your microSD card to PC
2) open "iGO8" folder
3) there should be the file "sys.txt". Open it using simple text editor (i.e. Notepad). Do not use MS Word or other powerful text processors.
4) find the section [gps] inside this file. If there is no [gps] section then create it
5) find the string "set_messages=" at the [gps] section. If there is no "set_messages=" string then create it.
6) edit this string adding "0" after "="

So, you shall get the following:
......
[gps]
set_messages=0
.......
7) Save the file "sys.txt", close your text editor, disconnect your microSD card from PC and return it to your GPS device.

This procedure will prevent the iGO8 software to send some unwanted messages to GPS chip. Those messages may switch the GPS chip from normal "NMEA data transfer mode" to 'Sirf binary data transfer mode".

Re: Explorist 510 Sat-Anzeige

Posted: Sun Oct 28, 2018 5:32 pm
by S1G
Das war damals, als Sockeye den mod programmiert hat, das gravierendste Problem. In der Tat sollte in der EXMOD.ini der Aufruf von IGO8 mit der nachgestellten 1 versehen werden. Dadurch wird der GPS-Chipsatz resettet. Alternativ kann auch ein anderes Programm darin aufgerufen werden und mit dem Resetaufruf versehen werden. Danach funktioniert wieder alles wie gewohnt.
Also keine Angst, da ist nichts kaputt. Nur falsch eingestellt.